Incorporating a highly efficient spur gearbox, the ProSeries windlasses utilize smaller, but more powerful, permanent magnet motors with lower amp draw and smaller diameter wires than those required by series wound motors driving worm gearboxes.

Overall, this makes for a lighter, less costly, and easier one-piece installation requiring no disassembly or motor alignment.

Lewmar 700H Pro Series Features

• All metal components are stainless steel - case, gypsy, chain stripper and control arm
• Direct replacement for Horizon 600 windlasses - exact same mounting hole pattern, but increased pulling power
• For Rope, or chain, or combination rodes (3-strand rope required)
• A clutch mechanism allows for emergency manual lowering
• Built-in emergency manual recovery system; uses a common 1/2" drive ratchet wrench such as Craftsman or Snap-on
• Footswitches and handheld remotes are available as additional control options; for dual control station installations it is most cost effective to use the 1000h
• Permanent magnet motor: 700h = 500 Watts
• 5 (Five) Year warranty (except 1 year on electrical components)
• Rope size 1/2", Chain Size 1/4"
• Power 12V
• Typical Max Pull (700lb)

Specifications

Gypsy No Motor Power Typical Power Typical Max Pull Maximum Line Speed Working Load Normal Current Draw Typical Line Speed/min Weight Circuit Breaker 503 12V 500W 700 105 175 35A 88 19 50A

Gypsy Number Chain Description Rope Description 503 1/4" G4/BBB 1/2" 3-strand and 8-plait

Dimensions

A(in) B(in) C(in) 5 3/4 9 5/8 7

• 700H Windlass
• Intelligent Mounting Studs, Washers and Nuts
• All-in-one Installation Wrench & Clutch Lever
• Base Gasket Seal
• Safety Instructions
• Mounting Template
• Instruction Booklet
• Warranty Registration Card
• Breaker/Isolator
• Control Switch